With the continuous development of the plastic production industry, it needs to be applied to the feeding equipment that meets the requirements of its production. The centralized feeding system of the injection molding machine can ensure the operation efficiency of the plastic molding and the stable operation of the whole system, and also prevent the blocking phenomenon. Production site, the injection molding machine centralized feeding system will be raw materials and dry barrel completely separate management with the site, saving space. Now many manufacturers have the application of injection molding machine centralized feeding system, then we all know the injection molding machine centralized feeding system what are the advantages and disadvantages? The following together to understand.

Advantages:

1, injection molding machine central feeding system is the use of single machine design and construction of single-tube to ensure that the entire injection molding machine central feed system is stable, the pipeline in a closed vacuum, no blocking phenomenon.

2, injection molding machine central feeding system is used with the central drying system, you can use the dry air to feed raw materials to prevent the drying of good raw materials resurgence.

3, Under the effect of vacuum negative pressure, the original dust in the raw materials will be filtered through the dust filtration system. After each single suction, the air filter can be reversely cleaned to avoid interference caused by the filter clogging.

4. At the same time, when the operator removes dust, Hengrong Company newly developed a non-stop motor design, thus subverting the traditional shutdown to clear the dust barrier. This design not only avoids the frequent start-up of the fan, but also increases the production efficiency.

Disadvantages:

1, high equipment costs.
2, one-time investment in materials, difficult to replace the variety of materials.

The above is the introduction of the merits and demerits of the injection molding machine centralized feeding system. In addition, the centralized management of the raw materials for the injection molding machine centralized feeding system avoids the waste and pollution, and can well maintain the quality stability, increase the output value and maintain the quality system.